The lifting platform adopts hydraulic chain intermodal mode. Three groups of mast-supported operation platforms are lifted and lowered synchronously, with excellent working stability. Beautiful appearance, small size, light weight, flexible and convenient movement, safe and reliable lifting operation.

可折叠式护栏，闲置时护栏可向下折叠降低自身高度，节省空间，作业时安装简洁便利。 升降操作设两套按钮，工作台面与台下都可控制。

Foldable guardrail. When idle, the guardrail can be folded down to reduce its height, saving space, and easy to install during operation. The lifting operation is equipped with two sets of buttons, which can be controlled on the working table and under the table.

框架采用优质矩形管焊接成型。 升降柱采用高强度铝合金型材，结构紧凑，并采用双链条牵引，安全系数大。 平台上升到高位置时有极限限位。

The frame is welded with high-quality rectangular tube. The lifting column is made of high-strength aluminum alloy profile, with compact structure and double chain traction, with high safety factor. There are limit stops when the platform rises to the high position.

产品应用:铝合金高空作业平台适用于商场宾馆饭店室内装修布置空间灯线管路门窗的维修保养及清洁，并适用于面积或空间狭窄房内的空间作业。

Product application: The aluminum alloy aerial work platform is applicable to the maintenance and cleaning of the interior decoration and layout of the space light lines, pipelines, doors and windows of the shopping malls, hotels and hotels, and is applicable to the space work in the rooms with narrow area or space.

一 操作使用

I. Operation and use

在作业前将支撑臂打开到135°，旋转支腿丝缸，将底座调至水平，系好安全绳，检查行程开关是否牢固灵敏，上控制按钮是否正常，便可操作平台升降，升至工作高度作业时工作人员必须配带安全带，并锁紧在身体和牢固的物体上。

Before operation, open the support arm to 135 °, rotate the outrigger screw cylinder, adjust the base to the horizontal, fasten the safety rope, check whether the travel switch is firm and sensitive, and whether the upper control button is normal, then the platform can be operated for lifting and lowering. When working at the working height, the staff must wear the safety belt and lock it on the body and solid objects.

升降操作：分为上下控制升降手电两用，按标注符号进行操作，使用前检察手压阀是否关闭，当作业时突然停电，可松开手压泵阀，升降机此时缓慢下降到低位置。

Lifting operation: It can be divided into two functions: up and down control, lifting and flashlight. Operate according to the marked symbols. Before use, check whether the hａnd pressure valve is closed. When the power is suddenly cut off during operation, release the hａnd pressure pump valve. At this time, the lift slowly lowers to the low position.

升降机作业时，电源线直径不的小于4平方mm，长度不的超过20米。

During elevator operation, the diameter of the power cord shall not be less than 4 square mm and the length shall not exceed 20 meters.

作业时勿将物品掉入滑道内。

Do not drop objects into the slide during operation.

不准超载作业。

Overloading operation is not allowed.

移动式升降机未降到低位置，不准移动整机。

The elevator is not allowed to move the whole machine until it is lowered to the low position.

风雨天气禁止室外作业。

Outdoor operation is prohibited in rainy weather.

二 注意事项：

2. Precautions:

升降机拆装时机体要垂直防止主体变形和漏油现象。

When disassembling the elevator, the body should be vertical to prevent the main body from deformation and oil leakage.

工作人员注意随身携带的工具和零部件，不要掉入支撑架内，防止卡坏链条。

The staff should pay attention to the tools and parts they carry with them, and do not fall into the support frame to prevent the chain from getting stuck.

使用该机前首先空升一次，仔细观察各部位是否正常有无异常声音，一经发现，应停止使用;由专业维修人员调试好后使用(电器元件保修三个月)。

Before using the machine, lift it once in the air, carefully observe whether each part is normal or abnormal, and stop using it once it is found; It shall be used after debugging by professional maintenance personnel (electrical components are guaranteed for three months).

三日常维护保养：该机为室内机，在室外使用时应在地质坚硬的地面上使用，以免发生，每使用20次调整一次链条螺丝调整一次保险绳螺丝，电器及液压系统应由专业人员维修。

III. Daily maintenance: This machine is an indoor machine. When used outdoors, it should be used on the hard geological ground to avoid overturning. The chain screw should be adjusted once every 20 times to adjust the safety rope screw. The electrical and hydraulic system should be repaired by professionals.