| Detection Method | Hall element |
| measurement range | 1Hz~20kHz(using a60P/R gear, 1~20,000
r/min, with an output waveform duty cycle is 50%±20%) |
| Detection gear | Strong magnetic materials(modulus
0.5~3, tooth width 3mm or greater |
| Gap between detector and gear |
| Power supply | used DC 12V±2V(0.5Vp~p or less ripple) |
| current consumption | 40mA or less(12V, at 25℃) |
| Otput waveform | Low level;+0.5V or less, High level;5V±0.5V
rectangular waveform(With no load) |
| Output impedance | Approx. 330? |
| Output type | Floating groung |
| Protective circuit | Power supply polarity and output short
protection |
| Operating temperature | range -10℃~+70℃ |
| Protective circuit | -20℃~+80℃ |
| Matching connector | 6-pin connector (type R04-PB6F plug) |
| Allowable vibration(during operation) | double-ended 1.2mm at 30Hz in X, Y,
and Z direction for one hour each. |
Allowable shock(non-operating)
| 490m/ S 2 in X and Y direction each 3 times. |
| Withstand voltage | 1.DC250V, 1min.(between shield and
signal cable)2.dc205V, 1min.(between shield and sensor head) |
| Interface indicator | YD-10, YD-20, YD-30 |
| weight | Approx.80g (including two mornting
nuts) |
| Accessories | Mounting nuts(2) |
