品牌
代理商厂商性质
西安市所在地
Dwyer DPM系列 粉尘浓度监控仪
面议Dwyer PMS系列 粉尘浓度传感器
面议Dwyer LCT116系列 数显式定时开关
面议Dwyer PMT系列 粉尘浓度变送器
面议Dwyer LCT016系列 模拟式定时开关
面议Dwyer DCT1000DC系列 定时反吹控制器
面议Dwyer CS系列 电流量开关
面议Dwyer MTL5041/5045系列 隔离栅
面议Dwyer DCT500A系列 经济型定时反吹控制器
面议Dwyer SI系列 智能数显表
面议Dwyer SCC系列 信号整定组件
面议Dwyer SC1090,班SCL1090系列 报警开关组件
面议Dwyer 2000 - HA 高精度MAGNEHELIC®微差压表
* 精度1% 。
* 镜像缩放叠加消除视差误差
* 六点校正证书
* IP67防护,*防护,可适合灰尘和浸水情况
* 可选耐腐蚀刷304 SS 边框
FEATURES/BENEFITS
• Accurate within 1%
• Mirrored scale overlay eliminates parallax error
• Six point calibration certificate included
• IP67 - Fully protects against dust and immersion
• Optional corrosion resistant brushed 304 SS bezel
APPLICATIONS
• Clean room positive pressure indication
• Filter monitoring
• Air velocity with Dwyer pitot tube
• Blower vacuum monitoring
• Fan pressure indication
• Duct, room, or building pressures
Note: Shown with optional -SS bezel
DESCRIPTION
The SERIES 2000-HA High Accuracy Magnehelic® Gage is twice as accurate as the standard Magnehelic® gage. The well-engineered High Accuracy Magnehelic® Gage offers a mirrored overlay as standard in order to eliminate any parallax error when taking measurements. A six point calibration certificate is included with each high accuracy model. The rugged IP67 casing helps fully protect against dust and water ingress. The redesigned corrosion resistant brushed 304 stainless steel bezel option offers a clean tapered design, yet minimizes the possibility of any dust accumulation on the edges.
SPECIFICATIONS
Service | Air and non-combustible, compatible gases (natural gas option available). Note: May be used with hydrogen.Order a Buna-N diaphragm. Pressures must be less than 35 psi. |
WettedMaterials | Consult factory. |
Housing | Die cast aluminum case and bezel with acrylic cover. Exterior finish is coated gray to withstand 168 hour saltspray corrosion test. |
Accuracy | ±1% FS (±1.5% on -0, -100PA, -125PA, -10MM and ±2% on -00, -60PA, -6MM ranges) throughout range at70°F (21.1°C). |
Pressure Limits | -20 in Hg to 15 psig (-0.677 bar to 1.034 bar). |
Overpressure | Relief plug opens at approximay 25 psig (1.72 bar), standard gages only. See Overpressure Protection note oncatalog page. |
Temperature Limits | 20 to 140°F (-6.67 to 60°C). |
Size | 4" (101.6 mm) diameter dial face. |
MountingOrientation | Diaphragm in vertical position. Consult factory for other position orientations. |
ProcessConnections | 1/8" female NPT duplicate high and low pressure taps – one pair side and one pair back. |
Weight | 1 lb 2 oz (510 g). |
StandardAccessories | Two 1/8" NPT plugs for duplicate pressure taps, two 1/8" pipe thread to rubber tubing adapters, and threeflush mounting adapters with screws. |
AgencyApprovals | Meets the technical requirements of EU Directive 2011/65/EU (RoHS II). |