| | | | | | Alarming and indicating by lamp when water overflown | | | Automatic operating for water supply when idle prevented | | | 11Pin socket type, with small-sized model, easy for repairing and maintenance | | | | | | | | | | Type | YS FS-C22-M5-4A | Rating Voltage | c | 動作/復歸抵抗 | Water Supply(drainage) | Water Overflow(Alarm) | 13.9KΩ/48.1KΩ | 13.7KΩ/21.7KΩ | Ambient temperature | -25℃∼40℃ | Relative humidity | 45∼ 85% | Insulation resistance | below 100M¥Ø(at DC 500V. Meg) | Relay output contact Rating | AC 220V, 5A (resistance load) | Relay lifetime | Electrical : above 100,000 times, Mechanical : a bove 3,000,000 times | | | |
| | | | | | | Install 4pole electrode bar to water tank then Floatless Switch attaches panel finally connects magnet to | | | switch. | | | Select Magnet Switch according to motor capacity of pump. | | | 4~5Ø is suitable for electrode bar made of stainless or brass | | | As to the length of electrode bar, select max and limits then set it. | | | Connect it with reference to connection diagram on the next page. | | | | | | | | | Be sure insulating on the electrode bar because removing insulating film on surface of electrode | | | bar causes malfunction | | | E3 Terminal of Electrode bar must be connected | | | Fix 11pin socket and Floatless switch into key groove then tighten with hasp. | | | | | | | | | | Water supply & drainage common contact | | | Water supply contact | | | Drainage contact | | | Alarm or lamp contact when water is overflown | | | Common contact when water is overflown | | | | | | | | | | Motor pump automatically stops when water level | | | reaches E1 | | | Motor pump automatically operates when water level | | | is under E2 | | | Alarming (Indicating lamp) when water level reaches | | | E4 | | | | Motor pump automatically operates when water level | | | reaches E1 | | | Motor pump automatically stops when water level is | | | under E2 | | | Alarming(Indicating lamp) when water level reaches | | | E4 | | | |