智能制造网

这些总线转换器将Vnet/IP上的CENTUM VP人机接口站(HISes)连接到V网上的CENTUM VP/CENTUM CS 3000/CENTUM CS站，以及其他域VL网上的CENTUM CS 1000站。
与CENTUM CS 3000/CENTUM CS系统对接时，需要安装VP6H4450多项目连接包和VP6E5450多项目连接构建器。要连接到CENTUM CS 1000系统，还需要一个以太网以及这些软件包。

有关各系统通用的安装规范和环境条件，请参考GS《综合生产控制系统CENTUMVP系统概述》(GS 33J01A10-01EN)。
Vnet/ip侧通信通信速度:100mbps，全双工连接:UTP电缆(CAT5e或更高)，RJ45连接器接口:100Base-TX兼容。距离:100m (AVR10D到二层交换机的距离)
在vnet端进行通信
通信速度:10mbps
连接方式:同轴电缆，BNC型
双冗余或单冗余
用于CENTUM VP CENTUM cs3000和CENTUM CS
VL网络端的通信
通信速度:10mbps
连接方式:同轴电缆，BNC型
双冗余或单冗余
为CENTUM cs1000
重新配置
巢
越来越多的
19英寸机架安装:机架安装(4个M5螺钉)，绝缘衬套(附件)连接电源:M4螺钉端子连接接地:M4螺钉端子连接v网和VL网侧:t结BNC连接vnetip侧:UTP电缆(CAT5e或以上)
电源电压:100 ~ 120vac，频率:50/ 60hzvoltage: 220 ~ 240v AC，频率:50/ 60hzvoltage: 24v DC
功耗100- 120vac: 80va220 – 240vac: 110va24v DC: 1.7A
供电方式双线或单线供电重量
约5.8公斤

These Bus Converters connect CENTUM VP Human Interface Stations (HISes) on the Vnet/IP to CENTUM VP/CENTUM CS 3000/CENTUM CS stations on the V net, CENTUM CS 1000 stations on the VL net in other domain.
To connect to CENTUM CS 3000/CENTUM CS System, VP6H4450 Multiple Project Connection Package and VP6E5450 Multiple Project Connection Builder are required. To connect to CENTUM CS 1000 System, an Ethernet, as well as these packages, is also required.

For the installation specifications and environmentalconditions that are common to the systems, refer to theGS “Integrated Production Control System CENTUMVP System Overview”(GS 33J01A10-01EN).
Communication on the Vnet/ip SideCommunication Speed: 100 Mbps, Full DuplexConnection: UTP cable (CAT5e or better), RJ45 connectorInterface: 100Base-TX compliance Max. distance: 100 m (Distance between AVR10D and Layer 2 switch)
Communication on the V net Side
Communication Speed: 10 Mbps
Connection: Coaxial cable, BNC type
Dual-redundant or single
For CENTUM VP CENTUM CS 3000 and CENTUM CS
Communication on the VL net Side
Communication Speed: 10 Mbps
Connection: Coaxial cable, BNC type
Dual-redundant or single
For CENTUM CS 1000
Co谍nfiguration
Nest
Mounting
19-inch Rack Mounting: Rack mount (4 x M5 screws), Insulation bush (accessory)ConnectionPower Supply: M4 screw terminal connectionGrounding: M4 screw terminal connectionV net and VL net Side: T-junction BNC connectionVnetIP Side: UTP cable (CAT5e or better)
Power Supply(Specify with Suffix Code)Voltage: 100-120 VAC, Frequency: 50/60 HzVoltage: 220-240 V AC, Frequency: 50/60 HzVoltage: 24 V DC
Power Consumption100-120 VAC: 80 VA220-240 VAC: 110 VA24 V DC: 1.7A
Power supply method dual-line or single power lineWeight
Approx. 5.8 kg